Installing The Thermal Sensor; Removing The Processor - Dell Precision T7600 Owner's Manual

Figure 61.

Installing the Thermal Sensor

1. Install the thermal sensor cable on the system board.
2. Route the thermal sensor cable around the computer chassis.
3. Fasten the latch that secures the thermal sensor cable.
4. Install:
a) air tunnel
b) right cover
c) left cover
5. Follow the procedures in

Removing the Processor

1. Follow the procedures in
2. Remove:
a) left cover
b) heat sink
3. To remove the processor:
NOTE: The processor cover is secured by two levers. They have icons that indicate which lever needs to be
opened first and which lever closes first.
a) Press down on the first lever holding the processor cover in place and release it sideways from its retention
hook.
b) Repeat step 'a' to release the second lever from its retention hook.
c) Lift up and remove the processor cover.
d) Lift the processor to remove it from the socket and place it in antistatic package.
After Working Inside Your Computer .
Before Working Inside Your Computer .
39