Calibrating The Embroidery Hoop; Entering The Fabric Thickness - Bernina 570 QE User Manual

> To open the embroidery design in the center of the hoop, set the switch «Restore saved embroidery
design position» to «0».

Calibrating the Embroidery Hoop

The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
• The embroidery module is connected.
• The hoop is fitted with the corresponding embroidery pattern.
> Tap «Home».
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Calibrating the Embroidery Hoop».
> Use the arrow icons on the display to move the needle precisely to the center of the pattern.
1
> To save the calibration, tap «Confirm».

Entering the Fabric Thickness

If the fabric thickness is more than 4 mm, e. g. such as terry cloth, then it is recommended to choose
7.5 mm or 10 mm. The thicker the fabric, the slower the machine embroiders. When the machine is
switched off, the changes are reset to the default setting of 4 mm.
> Tap «Home».
> Tap «Setup Program».
Setup Program
57