Removing Memory Modules - Dell DX6000G Hardware Owner's Manual

12 Start up the system, press <F2> to enter the System Setup program, and
check the System Memory setting on the main System Setup screen.
The system should have already changed the value to reflect the newly
installed memory.
13 If the value is incorrect, one or more of the memory modules may not be
installed properly. Repeat step 2 through step 12 of this procedure,
checking to ensure that the memory modules are firmly seated in their
sockets.
14 Run the system memory test in the system diagnostics. See "Running the
Embedded System Diagnostics" on page 160.

Removing Memory Modules

WARNING:
system has been powered down. Allow time for the memory modules to cool
before handling them. Handle the memory modules by the card edges and avoid
touching the components on the memory module.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
CAUTION:
To ensure proper system cooling, memory-module blanks must be
installed in any memory socket that is not occupied. Remove memory-module
blanks only if you intend to install memory in those sockets.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 80.
3 Remove the system board shroud. See "Removing the System Board
Shroud" on page 98.
4 Locate the memory module sockets. See Figure 6-1.
5 Press down and out on the ejectors on each end of the socket until the
memory module pops out of the socket. See Figure 3-17.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
The memory modules are hot to the touch for some time after the
Installing System Components
117