Dell DX6000G Hardware Owner's Manual page 147

2 Turn off the system and attached peripherals, and unplug the system from
the power source. Press the power button with the system unplugged, and
then reconnect the system to power.
3 Turn on the system and attached peripherals and note the messages on the
screen.
Go to step 12 if an error message appears indicating a fault with a specific
memory module.
4 Enter the System Setup program and check the system memory setting.
See "Memory Settings Screen" on page 59. Make any changes to the
memory settings, if needed.
If the memory settings match the installed memory but a problem is still
indicated, go to step 12.
5 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
6 Open the system. See "Opening the System" on page 80.
7 Check the memory banks and ensure that they are populated correctly.
See "General Memory Module Installation Guidelines" on page 111.
8 Reseat the memory modules in their sockets. See "Installing Memory
Modules" on page 115.
9 Close the system. See "Closing the System" on page 81.
10 Reconnect the system to its electrical outlet, and turn on the system and
attached peripherals.
11 Enter the System Setup program and check the system memory setting.
See "Memory Settings Screen" on page 59.
12 Turn off the system and attached peripherals, and disconnect the system
from the power source.
13 Open the system. See "Opening the System" on page 80.
14 If a diagnostic test or error message indicates a specific memory module as
faulty, swap or replace the module.
15 To troubleshoot an unspecified faulty memory module, replace the
memory module in the first DIMM socket with a module of the same type
and capacity. See "Installing Memory Modules" on page 115.
16 Close the system. See "Closing the System" on page 81.
Troubleshooting Your System
149