System Memory; Removing Memory Modules - Dell PowerEdge R630 Owner's Manual

3. If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing
bracket.
1. Align the tabs on the cooling shroud with the securing slots on the chassis.
2. Lower the cooling shroud into the chassis until it is firmly seated.
Figure 25. Installing the cooling shroud
a. cooling shroud
1. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Before working inside your system
After working inside your system
Removing the cooling shroud

System memory

Removing memory modules

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
NOTE: The memory modules are hot to touch for some time after the system has been powered down. Allow the memory
modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components
or metallic contacts on the memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that
is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
1. Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the
memory module or metallic contacts.
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module
socket.
3. Lift and remove the memory module from the system.
Installing and removing system components 79