Table of Contents
Advertisement
5
Using Firewall Protection
Configuring custom connections
To do this...
Modify an existing
service
Block an existing
service and close
its ports
Click Save.
5
(For a new policy, click Next, select additional options for the policy, then click Save.)
Configuring IP addresses
Use this SecurityCenter task to add or remove a range of IP addresses in a custom connection.
Client computers using this policy will accept communications originating only from the IP addresses
you add.
Task
For option definitions, click ? in the interface.
1
On the Policies page, click Add Policy (or click Edit to modify an existing policy).
2
Select Firewall Protection, then click the General Settings tab.
Under Connection Type, select Custom settings, then click edit.
3
On the Firewall Custom Settings panel, under Allowed Incoming Addresses, configure a range of IP
4
addresses for computers using this policy by using one of these methods.
To do this...
Accept communications from
any IP address
Accept communications from
IP addresses on the subnet
where the computers are
located
100
McAfee Total Protection Service 5.1.5 Product Guide
Perform these steps...
1 For a service listed in the table, click edit.
2 In the Add or Edit Incoming Connection panel, modify the name for the
service and/or the ports through which the service will communicate with
computers using this policy, then click OK.
1 For a service listed in the table, click Block.
2 Click OK.
The service is removed from the list, and computers using this policy will not
accept communications through the ports assigned to the blocked service.
Specify IP addresses and system service ports through which to
communicate by using separate tasks.
Perform these steps...
1 Select Any computer.
2 Click OK.
1 Select My network (the subnet only).
2 Click OK.
Advertisement
Table of Contents
