Configuring Ip Addresses - McAfee TSA00M005PAA - Total Protection Service Product Manual

Using Firewall Protection
Configuring custom connections
4 On the Firewall Custom Settings panel, under Allowed Incoming Connections, configure a
service by using one of these methods.
To do this...
Allow an existing service by opening its ports 1
To do this...
Add a new service and open its ports
Modify an existing service
Block an existing service and close its ports 1
5 Click Save. (For a new policy, click Next, select additional options for the policy, then
click Save.)

Configuring IP addresses

Use this task to add or remove a range of IP addresses in a custom connection. Client
computers using this policy will accept communications originating only from the IP addresses
you add.
NOTE: Specify IP addresses and system service ports through which to communicate by using
separate tasks.
Before you begin
On the Firewall Protection policy page, you must select Administrator configures firewall
before you can perform this task. You must also select a Firewall Protection Mode of Protect
or Report.
Task
For option definitions, click ? in the interface.
1 On the Policies page, click Add Policy (or click Edit to modify an existing policy).
2 Select Firewall Protection, then click the General Settings tab.
3 Under Connection Type, select Custom settings, then click edit.
92
McAfee Total Protection Service Product Guide
To do this...
Accept communications from any IP address 1
Perform these steps...
Select the checkbox for a service listed in the table.
2 Click OK.
Computers using this policy will accept communications through
the ports assigned to the service.
Perform these steps...
1 Click Add Connection.
2 In the Add or Edit Incoming Connection panel, type a name
for the service, type the ports through which the service
will communicate with computers using this policy, then
click OK.
1 For a service listed in the table, click edit.
2 In the Add or Edit Incoming Connection panel, modify the
name for the service and/or the ports through which the
service will communicate with computers using this policy,
then click OK.
For a service listed in the table, click Block.
2 Click OK.
The service is removed from the list, and computers using this
policy will not accept communications through the ports assigned
to the blocked service.
Perform these steps...
Select Any computer.