Pocket Milling—Roughing G845 (Y Axis) - HEIDENHAIN MANUALPLUS 620 User Manual

Pocket milling—roughing G845 (Y axis)
G845 roughs closed contours that are defined in the XY or YZ plane in
the program sections:
FACE_Y
REAR_Y
LATERAL_Y
Choose one of the following plunge strategies, depending on the
milling cutter you are using:
Plunge vertically
Plunge at a pre-drilled position
Plunge in a reciprocating or helical motion
When "plunging at a pre-drilled position," you have the following
alternatives:
Calculate positions, drill, mill. The machining process is
performed in the following steps:
Insert drill.
Calculate hole positions with "G845 A1 ..."
Drill holes with "G71 NF ..."
Call cycle "G845 A0 ..." The cycle positions the tool above the
hole; the tool plunges and mills the pocket.
Drill, mill. The machining process is performed in the following
steps:
Drill a hole inside the pocket with "G71 ..."
Position the milling cutter above the hole and call "G845 A0 ..."
The tool plunges and mills the section.
If the pocket consists of multiple sections, G845 takes all the sections
of the pocket into account for drilling and milling. Call "G845 A0 ..."
separately for each section when calculating the hole positions
without "G845 A1 ..."
G845 takes the following oversizes into account:
G57: Oversize in X, Z direction
G58: Equidistant oversize in the milling plane
Program oversizes for calculating the hole positions and
for milling.
HEIDENHAIN MANUALplus 620 415