HEIDENHAIN MANUALPLUS 620 User Manual page 263

Parameters
H Type of retraction (default: 3). Tool backs off at 45° against the
machining direction and moves as follows to the position I, K:
0: Diagonal
1: First X, then Z direction
2: First Z, then X direction
3: Stops at safety clearance
4: No retraction motion—tool remains on the end
coordinate
5: Diagonally to the tool position before the cycle call
6: First in X, then in Z to the tool position before the cycle
call
7: First in Z, then in X to the tool position before the cycle
call
X Cutting limit (diameter value)—(default: no cutting limit)
Z Cutting limit (default: no cutting limit)
D Omit elements (default: 1). Use the omit codes listed in the
table at right to omit individual elements, or the omit codes
listed in the table at the lower right to skip execution of
recesses, undercuts and relief turns.
I End point that is approached at the end of the cycle (diameter
value)
K End point that is approached at the end of the cycle
O Feed rate reduction for circular elements (default: 0)
0: Feed rate reduction is active
1: No feed rate reduction
U Cycle type—Required for generating the contour from the
G80 parameters. (default: 0)
0: Standard contour (longitudinal or transverse), recessing
contour or ICP contour
1: Linear path without/with return
2: Circular arc CW, without/with return
3: Circular arc CCW, without/with return
4: Chamfer without/with return
5: Rounding arc without/with return
B Tool-tip radius compensation (default: 0)
0: Automatic determination
1: To the left of the contour
2: To the right of the contour
The MANUALplus uses the tool definition to distinguish between
external and internal machining.
Undercuts are machined if they are programmed and if tool geometry
permits.
HEIDENHAIN MANUALplus 620
Codes for omitting recesses and undercuts
G call Function
G22 Recess for sealing ring
G22 Recess for guard ring
G23 H0 General recess
G23 H1 Relief turn
G25 H4 Undercut type U
G25 H5 Undercut type E
G25 H6 Undercut type F
G25 H7 Undercut type G
G25 H8 Undercut type H
G25 H9 Undercut type K
Add the codes if you want to omit several elements.
D code
512
1024
256
2048
32 768
65 536
131 072
262 744
524 288
1 048 576
263