Header Section; Turret Section - HEIDENHAIN MANUALPLUS 620 User Manual

Overview of program section codes
German
Subprograms
UNTERPROGRAMM
RETURN
Others
CONST
VAR
For more than one independent contour definition for
drilling/milling, use the program section codes (FRONT,
SURFACE, etc.) each time.

HEADER section

Instructions and information in the program head (HEADER):
Unit:
Select dimensional system in millimeters or inches:
No entry: The unit set in the user parameter is used.
The other fields contain organizational information and set-up
information, which do not influence the machining process.
Information contained in the program head is preceded by "#" in the
NC program.
You can only select a unit when creating a new NC
program. It is not possible to post-edit this entry.

TURRET section

The TURRET program section defines the assignment of the tool
carrier. For every assigned turret pocket, the tool ID number is
entered. For multipoint tools, every cutting edge is entered in the
turret list.
If you do not program the TURRET, the tools entered
in the tool list of the Machine operating mode will be
used.
HEIDENHAIN MANUALplus 620
English
SUBPROGRAM Page 39
Page 39
RETURN
CONST Page 40
Page 40
VAR
Example: Turret table
. . .
TURRET
T1 ID"342-300.1"
T2 ID"C44003"
. . .
37