Why Is The Hard Drive Light-Bar Purple; Why Is The Hard Drive Light-Bar Red - HP Mv2120 - Media Vault Network Drive User Manual

To reset the HP Media Vault
Double-click the HP Media Vault Monitor icon
1
On the HP Media Vault Control Center, click Tools, then click
2
Customize HP Media Vault.
Click the System tab, then click either the Shutdown or the Restart
3
icons in the upper right corner of the console.
Shutdown and restart the HP Media Vault manually
How to force the HP Media Vault to turn off and restart.
To perform a soft shut down and restart
On the back of the HP Media Vault, press the Power button.
1
The health light should begin blinking.
2
The shutdown process may take up to two minutes to complete.
After the HP Media Vault is completely off, press the Power button to
3
restart.
To force a shutdown and restart
If the HP Media Vault can not be restarted using any of the above methods,
then try disconnecting the power cord and reconnecting it.

Why is the Hard Drive Light-bar Purple?

A purple light bar
has not been initialized. It occurs in the following conditions:
User has clicked "Remove" on the discs tab.
•
When adding a new drive, before is has been added to HP Media Vault
•
storage.

Why is the Hard Drive Light-bar Red?

A red light-bar
replaced.
indicates that a hard drive has been installed, but
indicates that a hard drive has failed and must be
in the task tray.
12-