HP Mv2120 - Media Vault Network Drive User Manual page 162

Check all cords, cables, and outlets
Make sure all devices on your network are correctly installed and the
1
cables are connected to the proper ports.
Make sure you press in the power button.
2
Make sure your router has power.
3
Restart your router (or unplug and plug it back in).
4
Restart all the devices on your network, including your computers and the
5
HP Media Vault.
If you're using your own Ethernet cable, try using the Ethernet cable that
6
came with the HP Media Vault.
Check the LED lights on the front of the HP Media Vault
The Power Indicator LED
•
The Health Indicator LED
•
The Network Activity Indicator LED
•
Table 5: Health Code Indicators
Code
1-blue (short), 1-red (long)
1-blue (short), 2-red (long)
2-blue (short), 1-red (long)
Ensure that you have connected the HP Media Vault to the
correct network adapter
Do you have multiple network adapters connected to different physical
networks? If so, enable the network adapter on the network that you have
attached the HP Media Vault, and disable the other network adapters. You
12-
154
light should be blue.
should blue.
should blue.
Boot image missing
Failed Recovery
Unable to obtain DHCP
address
Action
Run firmware repair utility on
PC
Restart the HP Media Vault and
run firmware repair utility on
PC
Check router, If using a static IP
address, reconfigure the HO
Media Vault, for more
You prefer to
information see
set static IP Addresses on
page 12- 1 68
Version