Network Troubleshooting - Lexmark 22N0057 - X 5450 Color Inkjet User Manual

Decrease the
transmission speed
10
11
12
Caller ID information is not displayed
Caller ID pattern may
not be set correctly

Network troubleshooting

•
"The printer to be configured does not appear in the list of printers found on your network" on page 110
•
"Cannot print to the network printer" on page 111
•
"Network name does not appear in the list" on page 111
Note: If your printer came with a N4050e print server, see the installation instructions and User's Guide on the N4050e
Setup Utility CD.
The printer to be configured does not appear in the list of printers
found on your network
Check security keys
Check power
1
From the control panel, press Fax Mode.
2
Press .
3
Press or repeatedly until Fax Setup appears.
4
Press .
5
Press or repeatedly until Dialing and Sending appears.
6
Press .
7
Press or repeatedly until Max Send Speed appears.
8
Press .
9
Press or to select a lower transmission speed.
Press to save the setting.
Resend the fax.
If the problem persists, repeat step 1 through step 11 to resend the fax at successively
lower transmission speeds.
Note: 2400 bps is the lowest transmission speed.
Notes:
•
The lower the transmission speed, the longer it will take your fax to print.
•
This solution will reduce the speed for future faxes until you reset the transmission
speed.
The printer supports two distinct Caller ID patterns: Pattern 1 (FSK) and Pattern 2 (DTMF).
Depending on the country or region you live in and the telecommunications company you
subscribe to, you may need to switch the pattern in order for the printer to display Caller
ID information. For more information, see "Using Caller ID" on page 75.
SSID is not being broadcast. Make sure security keys are correct.
Make sure the printer is connected to a power source and is turned on. For more
information, see "Power button is not lit" on page 97.
Troubleshooting
110