Moving Memory Data To The Main (Vfo-A) Band - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

M
OVING
You may transfer the contents of the currently-selected memory channel into the Main band (VFO-A) register, if you like.
1. Press the [ V/M ] switch, as necessary, to go to the
Memory mode. The memory channel number will
appear in the multi-panel window.
2. Press the [ MCH/GRP ] key momentarily.
The Red LED inside the switch will light up, indicat-
ing that you are ready to recall a memory channel.
A A A A A
D D D D D VICE VICE VICE VICE VICE
If the Red LED imbedded in the [ MCH/GRP ] switch
does not light up, check to be sure that the orange
lamp to the right of the [ CLAR/VFO-B ] knob is not
illuminated. It is, press the [ A/B ] switch to make it go
out, then press the [ MCH/GRP ] key again.
3. Rotate the [ CLAR/VFO-B ] knob to select the memory
channel the contents of which you wish to transfer to
the Main band (VFO-A).
4. Press and hold in the [ M A ] key for two seconds,
until you hear the double beep. The data in the se-
lected memory channel will now be transferred to the
Main band (VFO-A).
FT 9000D O
DX PERATION
M D
EMORY ATA TO THE
M
ANUAL
M
EMORY
( VFO-A ) B
M
AIN
[ M A ] key [ MCH/GRP ] switch
A A A A A
D D D D D VICE VICE VICE VICE
VICE
This transfer of data to the Main band (VFO-A)
does not affect the original contents of the memory
channel; this is a "copy" function that leaves the
memory contents unchanged.
O
PERATION
AND
[ CLAR/VFO-B ] knob
Page 129