Repeater Operation - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

The FT 9000D may be utilized on 29 MHz and 50 MHz repeaters.
DX
1. Rotate the [ Main Tuning Dial ] knob to the output
frequency (downlink) from the repeater.
2. If CTCSS Tone operation is desired/needed, press and
hold in the [ FM ] Mode key for two seconds to en-
gage the CTCSS mode.
3. Rotate the [ Main Tuning Dial ] knob to select the
desired CTCSS mode. If you just need to send the
uplink encoding tone, select "tn." For encode/decode
operation, choose "ts" instead.
The available choices are
"OFF" "tn" "ts"
4. Rotate the [ CLAR/VFO-B ] knob to select the desired
CTCSS Tone to be used. A total of 50 standard CTCSS
tones are provided (see the CTCSS Tone Chart).
5. Press the [ FM ] Mode key to select the desired repeater
shift direction.
The selections are
"S" "+" "−"
where "S" represents "Simplex" operation (not used
on a repeater).
6. Press and hold in the [ FM ] Mode key for two sec-
onds to exit from the repeater setup mode.
7. Close the microphone's PTT switch (or press the
[ MOX ] switch) to begin transmission. You will ob-
serve that the frequency has shifted to correspond to
the programming you set up in the previous steps.
Speak into the microphone in a normal voice level,
and release the PTT or [ MOX ] switch to return to the
receive mode.
A A A A A
D D D D D VICE VICE VICE VICE
VICE
The conventional repeater shift used on 29 MHz is
100 kHz, while on the 50 MHz is 500 kHz. To
program the proper repeater shift, use Menu items
"MODE-FM 068 RPT SHIFT" (28 MHz) and
"MODE-FM 069 RPT SHIFT" (50 MHz), as ap-
propriate.
FT 9000D O
DX PERATION
R
EPEATER
[ FM ] mode key [ Main Tuning Dial ] knob
"OFF."
"S"
M
ANUAL
FM M
O
PERATION
CTCSS Tone Frequency
CTCSS Tone Frequency (Hz)
67.0 69.3 71.9 74.4
88.5 91.5 94.8 97.4 100.0 103.5 107.2 110.9
114.8 118.8 123.0 127.3 131.8 136.5 141.3 146.2
151.4 156.7 159.8 162.2 165.5 167.9 171.3 173.8
177.3 179.9 183.5 186.2 189.9 192.8 196.6 199.5
203.5 206.5 210.7 218.1 225.7 229.1 233.6 241.8
250.3 254.1
O
ODE PERATION
[ CLAR/VFO-B ] knob
CTCSS Operation
tn: Tone Encoder
tS: Tone Squelch
oFF: OFF
Repeater Shift Direction
S: Simplex
--: Minus Shift
+: Plus Shift
77.0 79.7 82.5 85.4
Page 119