Vl-1000 Linear Amplifier Interconnections - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

VL-1000 L
Be sure that both the FT 9000D and VL-1000 are turned off, then follow the installation recommendations contained
DX
in the illustration.
On the rear panel of the VL-1000, please set the "ATT" switch to the "ON" position. The 200-Watt power output from the
FT 9000D is far in excess of what is required to drive the VL-1000 to its full rated output.
DX
N N N N N
O O O O O TE TE TE TE TE
Please refer to the VL-1000 Operating Manual for details regarding amplifier operation.
Please do not attempt to connect or disconnect coaxial cables when your hands are wet.
Control Cable Modification
Pin 3
GND
Pin 7
TRQ
Please cut off the RCA connector on one end of
the CONTROL Cable supplied with the VL-
1000, and install a 7-pin DIN connector in its
place, according to the illustration.
2 1
FT 9000D O
DX PERATION
I
A
INEAR MPLIFIER
Pin 9
F SET COMMON
Pin 11
F SET 2
BAND DATA CABLE （ Supplied w/VL-1000
CONTROL CABLE User constructed （
ALC CABLE Supplied w/VL-1000 （
M
ANUAL
NSTALLATION AND
I
NTERCONNECTIONS
About the CONTROL Cable
The VL-1000 may be operated with the FT
9000D whether or not the CONTROL Cable is
connected; however, the CONTROL Cable allows
you to tune up the amplifier automatically by just
pressing the [ F SET ] or [ TUNE ] key on the VL-
1000, so as to transmit a carrier for tuning pur-
poses.
To link the FT 9000D and VL-1000 Power
DX
switches, set the VL-1000 REMOTE switch to the
ON position.
ANTENNA CABLE Supplied w/VL-1000 （
ANTENNA
ANT 1
REMOTE
ANT 2 BAND DATA 1
ANT 3
ANT 4
BAND DATA 2
）
）
）
I
NTERCONNECTIONS
DX
）
INPUT 1
PTT 1
ON
OFF
PTT 2
INPUT 2
ALC 1
CONTROL
ALC 2
DC48V IN
GND
Page 17