Memory Groups; Memory Group Assignment; Choosing The Desired Memory Group - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

M G
EMORY ROUPS
1. Press the [ MNU ] key to enter the Menu mode.
2. Rotate the [ Main Tuning Dial ] knob to select Menu
item "GENERAL 038 MEM GROUP."
Rotate the [ CLAR/VFO-B ] knob to set this Menu
item to "ENABLE" (the default setting is "DIS-
ABLE").
3. Press and hold in the [ MNU ] key for two seconds to
save the new setting and exit. Operation will now be
restricted to the six Memory Groups.
To cancel Memory Group operation, repeat steps (1)
through (3) above, choosing "DISABLE" in step (2).
You may recall memories just within a particular Memory Group, if desired.
1. Press the [ V/M ] key, if necessary, to enter the Memory
mode.
2. Press and hold in the [ MCH/GRP ] key (below and to
the left of the [ CLAR/VFO-B ] knob) for two sec-
onds. The imbedded LED inside the switch will light
up.
3. Rotate the [ CLAR/VFO-B ] knob to select the desired
Memory Group.
Page 124
M G
EMORY ROUP
C D
HOOSING THE ESIRED
A
SSIGNMENT
[ MCH/GRP ] switch
A A A A A
D D D D D VICE VICE VICE VICE VICE
Note that for the PMS memory group, the PMS
memories "P1L" through "P9U" will be so desig-
nated, so as to avoid confusion.
Memory Channel Number
Groups Memory "OFF"
01 ~ 19
20 ~ 39
40 ~ 59
60 ~ 79
80 ~ 99
P-1L/1U ~ P-9L/9U
M G
EMORY ROUP
[ V/M ] key [ MCH/GRP ] switch
To exit from Memory Group operation, press and hold in
the [ MCH/GRP ] key for two seconds once more.
A A A A A
D D D D D VICE VICE VICE VICE VICE
You will now be operating using memories only
within the selected Memory Group.
If no channels have been assigned to a particu-
lar Memory Group, you will not have access to
that Group.
FT 9000D O
DX
[ MNU ] key
[ CLAR/VFO-B ] knob
Groups Memory "ON"
1-01 ~ 1-19
2-01 ~ 2-20
3-01 ~ 3-20
4-01 ~ 4-20
5-01 ~ 5-20
P-1L/1U ~ P-9L/9U
[ CLAR/VFO-B ] knob
M
PERATION ANUAL