Removing Memories From A Memory Bank; Changing A Memory Bank's Name - Yaesu FT-2900R Operating Manual

M
EMORY

Removing Memories from a Memory Bank

1. While operating in the Memory Bank mode, recall the memory channel to be removed
from a Memory Bank.
2. Press and hold in the [ D/MR ( MW )] key for one second, then press the [ A/N ( LOW )] key to
remove the memory channel data from the Memory Bank.
You must first enter the Memory Bank mode, by pressing the microphone's [
key , before attempting to remove a channel from a
Bank. If you don't, "MCHERR" will appear when you press
the [ A/N ( LOW )] key in step ( 2 ) above.

Changing a Memory Bank's Name

You may change the default Memory Bank Name, which is indicated on the display when
you've selected a Memory Bank, to a different name, if desired.
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "9 BNK NM
2. Press the [ MHz ( SET )] key momentarily, then rotate the
DIAL knob to recall the memory bank on which you wish
to change a label.
3. Press the [ A/N ( LOW )] key to enable changing of the name tag.
4. Rotate the DIAL knob to select the first digit of the desired
label.
5. Press the [ A/N ( LOW )] key to move to the next character.
6. If you make a mistake, press the [ REV ( DW )] key to back-space the cursor, then re-enter
the correct letter, number, or symbol.
7. Repeat steps 4 through 6 to program the remaining letters,
numbers, or symbols of the desired label. A total of six char-
acters may be used in the creation of a label.
8. When you have programmed a name which is under 6 characters, press and hold in the
[ MHz ( SET )] key for one second to confirm the label and exit to normal operation.
40
O
PERATION
M B
EMORY
9 BNK NM." 9 BNK NM 9 BNK NM
9 BNK NM
O
ANK PERATION
FT-2900R O M
PERATING ANUAL
]