Yaesu FT-2900R Operating Manual page 76

" ( M
"S
ET
R S
EPEATER ETTING
Activates/Deactivates the Automatic Repeater Shift
feature.
Sets the Repeater Shift direction.
Sets the magnitude of the Repeater Shift.
CTCSS/DCS/EPCS S
Selects the CTCSS/DCS/EPCS Bell Ringer repeti-
tions.
Setting of the DCS code.
Enables/Disables "Inverted" DCS code decoding.
Enables/Disables the Enhanced CTCSS Paging &
Code Squelch function.
Enables/Disables the Answer Back function of the
Enhanced CTCSS Paging & Code Squelch function.
Setting the Receiver Pager Code for the Enhanced
CTCSS Paging & Code Squelch function.
Setting the Transmitting Pager Code for the Enhanced
CTCSS Paging & Code Squelch function.
Enables/Disables the split CTCSS/DCS coding.
Selects the Tone Encoder and/or Decoder mode.
Setting of the CTCSS Tone Frequency.
Enables/Disables the receiver audio output during the
Tone Search Scanner is activated.
Selects the Tone Search Scanner speed.
ARTS™ S
ETTING
Selects the Beep option during ARTS™ operation.
Selects the Polling Interval during ARTS™ operation.
Enables/Disables the CW identifier during ARTS™
Operation.
M S
EMORY ETTING
Select the Memory Bank for the Memory Bank Link
Scan.
Programming an Alpha/Numeric label for a Memory
Bank.
Selects the method of selection of channels for
Memory Storage.
Programming an Alpha/Numeric label for a Memory
Channel.
Enables/Disable the Band-edge beeper while scan-
ning.
Selects the Memory Scan mode.
SCAN S
ETTING
Selects the Scan Resume mode.
Selects the Memory Scan mode.
Select the VFO Scanner Width.
DTMF S
ETTING
Enables/Disables the DTMF Autodialer feature.
Setting of the DTMF Autodialer's TX Delay Time.
Loading of the DTMF Autodialer Memories.
Setting of the DTMF Autodialer Sending Speed.
72
) M
ENU
ETTING
ODE
S M I
ET ODE TEM
4 ARS
43 RPT
46 SHIFT
S M I
ET ODE TEM
7 BELL
14 DCS CD
15 DCS RV
32PAGER
33 PAG.ABK
34 PAG.CDR
35 PAG.CDT
48 SPLIT
49 SQ TYP
52 TN FRQ
54 TS MUT
55 TS SPD
S M I
ET ODE TEM
2 AR BEP
3 AR INT
11 CW ID
S M I
ET ODE TEM
8 BNK.LNK
9 BNK NM
29 MW MD
30 NM SET
21 EDG.BEP
28 MEM.SCN
S M I
ET ODE TEM
41 RESUME
47 SKIP
56 VFO.SCN
S M I
ET ODE TEM
17 DT A/M
18 DT DLY
19 DT SET
20 DT SPD
FT-2900R O
( D
A V
VAILABLE ALUES
ON / OFF
–RPT / +RPT / SIMP
0.00-99.95 ( MHz ) ( 0.60MHz )
( D
A V
VAILABLE ALUES
1 / 3 / 5 / 8 / CNTNUE / OFF
104 standard DCS codes
( 023 )
ENABLE / DISABL
ON / OFF
ON / OFF
--- ( 05 _ 47 )
--- ( 05 _ 47 )
ON / OFF
TONE / TSQL / DCS / RV TN /
OFF
50 standard CTCSS tones
( 100 Hz )
ON / OFF
FAST / SLOW
( D
A V
VAILABLE ALUES
IN RNG / ALWAYS / OFF
25SEC / 15SEC
ON / OFF
( D
A V
VAILABLE ALUES
---
---
NEXT / LOWER
---
ON / OFF
TAG1 / TAG2 / ALL CH
( D
A V
VAILABLE ALUES
BUSY / HOLD / 3SEC / 5SEC /
10SEC
SKIP /ONLY / OFF
±1MHz / ±2MHz / ±5MHz / ALL
( D
A V
VAILABLE ALUES
MANUAL / AUTO
50 / 250 / 450 / 750 / 1000 (ms)
---
50 / 100 (ms)
M
PERATING
)
EFAULT
)
EFAULT
)
EFAULT
)
EFAULT
)
EFAULT
)
EFAULT
ANUAL