Footswitches - DigiTech JAMMAN Owner's Manual

Footswitches

24. Delay Footswitches
These footswitches are used to turn on and off the JamMan
delay effect. Footswitches 1 – 3 select three different pre-programmed
delay settings. Press any of these to turn on the delay effect (LED is on).
To bypass the delay effect, press the active footswitch again (LED will
turn off).
The Tempo footswitch is used to modify the delay time by tapping in the
desired delay tempo.
25. Looper Footswitches
This row of 4 footswitches is used to control the JamMan Delay's looper.
The Rec/Play/Overdub footswitch initiates recording (LED lights red)
and playing (LED lights green) of the loop phrase. When a phrase is
playing back, it can be used to enable overdubbing (LED lights yellow)
over the recorded phrase. During playback, this footswitch can be
pressed and held to undo or redo the last overdub take.
The Tempo/Stop footswitch is used for stopping playback of a
recorded phrase and setting the loop tempo. Pressing and holding this
footswitch will clear any unstored loop audio.
The Loop Down footswitch will select the previous loop. If a loop is
currently playing, this will cue up the next loop to play as indicated by
the flashing number in the display.
The Loop Up footswitch will select the next loop. If a loop is currently
playing, this will cue up the next loop to play as indicated by the flashing
number in the display.
Guided Tour - Front Panel
Delay's
®
17