Assigning Effects To Footswitches (Stomp Mode Only) - DigiTech RP360 Owner's Manual

Assigning Effects To Footswitches
(Stomp Mode Only)
When the RP360/RP360XP is configured for
Stomp Mode operation, effects can be assigned to
any of the three footswitches� You can then toggle
individual effects in a preset on and off during
performance�
To assign an effect to one of the three footswitches:
1�
The RP must be configured for "Stomp Mode" operation, see Footswitch Modes on page
41 for information on configuring the RP for Stomp Mode operation�
2�
From the Performance state, press the
3�
Turn the
SELECT
effects chain�
4�
Turn the corresponding
C footswitches�
5�
When done, press the
6�
Store the changes to a user preset, see Storing/Copying/Naming Presets on page 17�
RP360 / RP360 XP
24
SELECT
knob and select the
knobs to select the effects which will be assigned to the A, B, and
EDIT
button to return to the Performance state�
BACK
1 Plexi-Drive
Stompbox FSW
MOD DLY REV
DIST ON
ASSIGN A
knob to enter the Effect Edit menu�
(Footswitch Assign) icon located at the end of the
1/1
E
X
LOOPER READY
P
WAH ON DLY ON
ASSIGN B ASSIGN C