Using Optional Sd/Sdhc Memory Cards - DigiTech JAMMAN SOLO Owner's Manual

Using Optional SD/SDhC Memory Cards

The JamMan Solo offers 35 minutes of
®
total built-in loop memory storage. You
can increase the loop memory by installing
an optional SD/SDHC memory card into
the SD card slot found under JamMan
Solo's PEDAL SWITCh. The JamMan
Solo is compatible with SD/SDHC card
sizes up to 32GB for over 16 hours of total
loop memory.
The first time a memory card is inserted
into the JamMan Solo, it is recommended
that you format the card using the JamMan
Solo's format procedure (see page 38 for
formatting instructions).
To install an optional SD/SDHC memory
card into the JamMan Solo, follow these
steps:
1. Disconnect the power supply.
36
2. Depress either of the two
SWITCh RELEASE PINS fully using
the 1/4" plug on a guitar cable.
3. Lift and remove the
from the JamMan Solo chassis.
4. Insert the memory card into the card
slot contacts face down and press until
it seats solidly. To remove the memory
card, press on the edge to activate the
spring mechanism that pops the card out
slightly and then gently pull the card out.
5. Replace the PEDAL SWITCh
by placing one hole of the PEDAL
SWITCh over its corresponding pin.
6. Push the opposite pin in and lower the
other side of the PEDAL SWITCh
into place over the depressed pin.
Release the pin. When the PEDAL
SWITCh is properly fastened, both
release pins are flush with the outer side.
PEDAL
PEDAL SWITCh