Loop / Single Phrases - DigiTech JAMMAN SOLO Owner's Manual

Loop / Single Phrases

Any phrase recorded into the JamMan
Solo can be played in two ways: either as
a continuous Loop, or as a Single "one-
shot" sample. Single phrases play the
recorded phrase only once and stop. All
phrases are recorded as loops by default
but they can be changed to a Single phrase
if desired. You can always change Single
phrases back to Loops later without
harming the phrase. To change between
Single and Loop, follow these steps:
1. Stop loop playback if it is playing.
2. Select a previously recorded Loop
phrase (LOOP LED is lit) using the
LOOP SELECT buttons. If the
CARD MEM LED is lit, you have
selected a memory location on the
optional memory card.
28
3. Press and hold the
®
STORE buttons simultaneously to
enter the Setup menu. The LOOP
LED will now be flashing and Lo
(Loop) will shown in the DISPLAY.
4. Use the
select the SINGLE LED so it begins
flashing (The display will show Si).
If changing from a Single to a Loop
phrase, use the LOOP SELECT
buttons to select the LOOP LED so
it begins flashing. The STORE button
will light to indicate this change must
be stored if it is to be recalled later.
5. Press the
store the changes, if desired.
TEMPO and
LOOP SELECT buttons to
STORE button twice to