Copy A Loop To A Different Memory Location - DigiTech JAMMAN SOLO Owner's Manual

Copy a Loop to a Different Memory Location

Stop any playback
1
activity by pressing the
PEDAL SWITCH two
times quickly.
Press the STORE
3
button. The STORE
button and the
DISPLAY will begin
to flash (the
DISPLAY shows the
current loop
memory location).
NOTE: Clear and Overdub Undo/Redo functions cannot be performed with the loop after a
Store/Copy procedure.
If dF appears in the display, this indicates the internal or external memory is full. Loops should be archived
using the JamManager
If when storing to an external SD card you see CP in the display, this indicates the SD copy
protection switch is in the "Locked" position.
2
Select a memory
location that contains a
loop that you want to
copy (either the LOOP
or SINGLE LED is lit).
TM librarian and then deleted from the JamMan
Use the LOOP SELECT buttons to
4
select an empty memory
location (the LOOP and SINGLE
LEDs are off). You can also store
over existing loops if you decide to.
If the CARD MEM LED is lit, you
will be storing to a memory location
on the optional memory card. Press
the PEDAL SWITCH to abort.
Press the STORE
5
button again. The loop
is now copied to the
new memory location.
® Solo to free up memory.
21