Three-Digit Code Entry Method - Universal Remote Control AVEX R6 - SPECS SHEET Owner's Manual

I Q S -U , :
F UICK ET P DID NOT WORK TRY THIS NEXT
Three-Digit Code Set-Up Method
STEP 1: Find the 3-digit code numbers assigned to
your brand from the lists in the back of this manual. The
codes are listed by component category (i.e., TV,
VCR, DVD, etc.), then by brand name. For instance,
if you would like to locate a code for a Sony
television, first locate the TV category and then look
for the Sony brand.
STEP 2: Once you have located the 3-digit codes
for each of the components that you wish to operate
with your AVEX R6, write them ALL down on a piece
of paper. It's important that you write down all the
codes listed for your brand because only one code is
going to work with your component.
STEP 3: Manually or using your old remote, turn on
the component you want to program—for example,
to program your TV turn on your TV set.
STEP 4: On the AVEX R6, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component LED light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds,the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
COMPONENT
BUTTONS
SELECT
BUTTON
Page 8