Basic Setup; Pre-Programmed Method - Universal Remote Control MX-350 - SPECS SHEET Owner's Manual

T h e M X - 3 5 0
Selecting a New DEVICE Changes
All Button Commands Instantly
The MX-350 can operate ten different devices even though it is only one
remote control. Let's try it now! Press the MAIN button, then press the TV
DEVICE button.
MAIN
Button
The top of the screen changes from MAIN to TV. Now all of the buttons
change their function to operate a TV. Press the page buttons. Watch the
labels of the display buttons change with each press. There are eight pages
of display buttons already labeled for TV operation. To operate another
component (e.g., VCR, DVD etc.), press the MAIN button to return to the
MAIN menu. The MAIN menu displays five of your Devices on the
screen. Simply press one of the screen-labeled Device buttons to operate
another device. If you don't see the device name you want, then use the
PAGE buttons to display the remaining five devices on page 2 of the
MAIN menu.
Light Button
Press the LIGHT button to backlight all the buttons. To turn off the back-
lighting, press the LIGHT button again, or just wait ten seconds (the back-
lighting automatically shuts itself off).
4
TV
DEVICE
Button
LIGHT
Button
U n i v e r s a l R e m o t e C o n t r o l , I n c .

Basic Setup

You can start setting up your MX-350 using either the Pre-Programmed
Method or the Learning Method. However, all the buttons of the MX-350 are
setup at once with the Pre-Programmed Method, so it is usually faster than
the one-button-at-a-time Learning Method.

Pre-Programmed Method

Power on the A/V component you wish to setup, so that you can test
1
codes by sending power off commands.
Refer to the pre-programmed code tables on pages 38 - 59 and
2
write down the code numbers listed for your A/V component. The
code numbers are listed by categories of devices, then by brand.
See page 37 for a category list.
Press and hold both the MAIN and ENT (Enter) buttons for approxi-
3
mately three seconds. The top of the display will show "SETUP".
You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don't press a button within that time, the MX-350 will time out and return to
normal operation.
MAIN
Button
5
ENT
Button