Basic Setup; Pre-Programmed Method - Universal Remote Control omega MX-650 Owner's Manual

U n i v e r s a l R e m o t e C o n t r o l , I n c .

Basic Setup

You can start setting up your Omega using either the Pre-Programmed
Method or the Learning Method. However, all the buttons of the Omega
are setup at once with the Pre-Programmed Method, so it is usually faster
than the one-button-at-a-time Learning Method.

Pre-Programmed Method

Power on the A/V component you wish to setup, so that you can test
1
codes by sending power off commands.
Refer to the pre-programmed code tables on pages 37 - 52 and
2
write down the code numbers listed for your A/V component. The
code numbers are listed by categories of devices, then by brand.
See page 37 for a category list. Code tables with model numbers
are available at www.universalremote.com in the MX-650 area.
Press and hold both the MAIN and ENT (Enter) buttons for approxi-
3
mately three seconds. The top of the display will show "SETUP".
You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don't press a button within that time, the Omega will time out and return to
normal operation.
MAIN
Button
5
ENT
Button