Idle-Up "Idlup - FUTABA 3PKS Instruction Manual

Idle-Up "IDLUP"

Use this function to improve the starting characteristics of the engine by raising the
idling speed when starting the engine of a gas powered car.
Operation
Offsets the throttle neutral position to the forward side or brake side.
Switch Setting
Select the idle-up function ON/OFF switch with the function select switch function. (See
page 79)
Operation Display
While this function is ON, the LED blinks. (When LED is ac-
tive) also appears on the initial screen and menu screen.If
the power switch is turned on while the idle-up switch is on, an
audible alarm will be heard. Immediately set the Idle-Up switch
to OFF.
Calling the setup screen
*Calling from menu screen
(Opening Screen)
Menu screen call
by
MENU 1
MENU1/2 selection
by button
MENU 2
Select the function
by button
Press t
he button
* When the direct call button is set,
the setup screen is also called by the
following method:
(Opening Screen)
Press t he
DIRECT SEL
Press the button set
at this function.
Idle-Up function adjustment
(Preparation)
- Use the function select switch function to select the switch.
1
(Idle-Up rate)
Use the (+) and (-) buttons to set the Idle-Up rate.
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
button
button
Idle-Up "IDLUP"
(Throttle system)
Warning display
The LED blinks while the Idle-Up
function is on.
Idle-Up on/off state.
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Idle-Up rate (RATE)
D50% ~ D1%, 0%, U1% ~ U50%
Initial value: 0%
"D": Brake side
"U": Forward side
75