Installing the accessory APA steering wheel offset adapter
• Obtain a 2.5mm hex wrench and philips screwdriver.
• Install the steering wheel unit removed as described on the preceding page as follows:
1
Connect the steering wheel unit con-
nector (be careful of the direction of
the connector) through the adapter,
and install the adapter using the 4 ac-
cessory hex bolts.
Modifying for left-hand use
• Obtain a 2.5mm hex wrench and philips screwdriver.
• Install the steering wheel unit removed as described on the preceding page as follows:
1
Remove the wheel section rear
cover using the hex wrench.
2
Push in the disconnected connector
so that it can be connected at the
opposite side.
• The photo below shows the connector at
the front. Push it to the opposite side.
2
Install the steering wheel unit, steer-
ing wheel cover, and wheel to their
original positions.
3
At the opposite side, connect the
steering wheel unit connector and
Install the steering wheel unit,
steering wheel cover, and wheel to
their original positions.
25