Ch3 Position Setting - FUTABA 3PDF Instruction Manual

(Description is with the CH3 lever position in the initial setting)
* Before using this function to select the servo position
to used with each function. Select the CH3 operation
function selection function. (P32).
(When LIN Type is Set)
The maximum travel can be set
When used with MC510CB
-Screen Display + 100~140A
-Screen Display -100~10A
First set to +100 with the CH3 lever and drive the car. If the car is difficult
to drive decrease the displayed value by moving the lever to the - side.
(When 1P~4P Type is set)
the servo operation position for each position can be set
by calling the setup screen for each position by operating
the CH3 lever.
1
When the initial screen or a function mode setup
screen is displayed. You can view the CH 3 posi-
tion by moving the CH 3 lever up or down. If the
lever is not operated for 5 seconds the display
will return to the initial screen.
(LIN Type Setting)
2
When adjusting the lever up side throw hold the
lever in the top position. If the tone changes ad-
just the throw with the + or - key.
When setting the lever down side throw hold the
lever in the down position. If the tone changes
adjust the throw with the + or - key.
(1P ~ 4P Type Setting)
To view each position operate the CH 3 lever
and set the servo operation position by pressing
the + or - key.

CH3 Position Setting

When a System Mode Group screen is displayed the CH 3
position will not be displayed.
CH3 Lever
MODE
RESET
SELECT
Setting Range: -100~+100
(Pressing the + and - keys simul-
taneously will return the value to
the initial value 0 )