Throttle Atv - FUTABA 3PDF Instruction Manual

This function is used to adjust the forward and brake side
servo travel. Each direction can be adjusted independent
of each other. Use this feature to set the throttle servo
travel.
Warning
Be sure that your throttle linkage does not apply exces-
sive force to the servo.
If your linkage installation causes an unreasonable amount of force to be ap-
plied to the servo. The servo may be damaged and result in loss of control.
(Throttle ATV Selection)
1
Access this function by pressing the MODE KEY
from the initial screen.
2
Access the THROTTLE ATV screen by pressing
the MODE KEY four times.
(Throttle Forward Side Adjustment)
3
Pull the throttle trigger back and adjust the for-
ward side travel by pressing the + or - key. When
a FET Amp (Electronic speed control) is used set
to 100.
(Throttle Brake Side Adjustment)
4
First set the ATL lever to the maximum travel po-
sition (100).
5
Push the throttle trigger fully forward adjust the
servo travel by pressing the + and - keys.
When an FET Amp (Electronic speed control) is
used set to 100.

Throttle ATV

MODE
MODE
1:
Initial Screen
10.5V
MODE
FUNCTION
MODE
MODE
MDL.SEL
MODE
TH.EXP
MODE
ST.ATV
MODE
TH.ATV
MODE
ST.EXP
MODE
Function Mode
Group
Setting Range: 0~120
(Pressing the + and - keys simul-
taneously returns setting to initial
value 100)
Setting Range: 0~120
(Pressing the + and - keys simul-
taneously returns the initial value
100)