HP Ew2400 - JetDirect Print Server Administrator's Manual page 94

Table 3.4 Telnet Commands and Parameters (16 of 18)
webscan-config
scan-idle-timeout
scan-email-config
MFP-config
usb-mode
usb-speed
ENWW
(Web Scan Config) Enables or disables the Web Scan
feature on the print server when connected to a supported
device. 0 disables, 1 (default) enables.
Specifies the number of seconds (1 - 3600) that an idle scan
connection is allowed to remain open. 0 disables the
timeout. The default is 300 seconds.
(Email Scan Config) Enable or disable the scan-to-email
feature in the Web Scan server. 0 disables, 1 (default)
enables.
(MFP config) Enable or disable print server support of the
client software provided with your multifunction or all-in-one
peripheral.
0 (default): disables client software support (allows printing
only).
1: enables client software support (allows printing and
scanning).
Specifies the communication mode over the USB port on the
HP Jetdirect print server.
Auto (default): Automatically negotiates and sets the
highest communication mode possible for the attached
printer or device.
MLC: (Multiple Logical Channels) An HP-proprietary
communication mode that allows multiple channels of
simultaneous print, scan and status communications.
BIDIR: A standard connection that supports
bi-directional communications between the printer and
print server. The print server sends print data and
receives status from the printer.
UNIDIR: A standard connection in which data is
transferred in one direction only (to the printer).
(Read-only parameter, USB 2.0 products only) Specifies the
autonegotiated communication speed over the USB
connection between the HP Jetdirect print server and the
device.
Full Speed: 12 Mbits/sec as specified in the USB v2.0
specifications, compatible with USB v1.1 specifications.
Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
Disconnected: The USB port is not connected.
TCP/IP Configuration 94