HP Ew2400 - JetDirect Print Server Administrator's Manual page 57

Table 3.3 TFTP Configuration File Parameters (8 of 12)
get-cmnty-name:
(get-community-name:)
Specifies a password that determines which SNMP GetRequests the HP Jetdirect
print server will respond to. This is optional. If a user-specified get community name
is set, the print server will respond to either a user-specified community name or
the factory-default. The community name must be ASCII characters. The
maximum length is 255 characters.
set-cmnty-name:
(set-community-name:)
Specifies a password that determines which SNMP SetRequests (control
functions) the HP Jetdirect print server will respond to. The community name of
an incoming SNMP SetRequest must match the print server's "set community
name" for the print server to respond. (For additional security, you may limit
configuration access through the print server's host access list). Community
names must be ASCII characters. The maximum length is 255 characters.
auth-trap:
(authentication-trap:)
Configures the print server to send (on) or not send (off) SNMP authentication
traps. Authentication traps indicate that an SNMP request was received, but the
community name check failed. The default is "on."
trap-dest:
(trap-destination:)
Enters a host's IP address into the HP Jetdirect print server's SNMP trap
destination list. The command format is:
trap-dest: ip-address [community name] [port number]
The default community name is "public"; the default SNMP port number is "162".
The port number cannot be specified without a community name.
If a "trap-community-name" command is followed by "trap-dest" commands, the
trap community name will be assigned to those entries unless a different
community name is specified in each "trap-dest" command.
To delete the table, use "trap-dest: 0".
If the list is empty, the print server does not send SNMP traps. The list may contain
up to three entries. The default SNMP Trap Destination List is empty. To receive
SNMP traps, the systems listed on the SNMP trap destination list must have a trap
daemon to listen to those traps.
IPX/SPX
ipx-config:
(ipx/spx:)
Enables or disables IPX/SPX protocol operation on the print server: 0 disables,
1 (default) enables.
ENWW
TCP/IP Configuration 57