HP Ew2400 - JetDirect Print Server Administrator's Manual page 82

Table 3.4 Telnet Commands and Parameters (4 of 18)
wpa-auth-type
psk-passphrase
dynamic-encrypt
802.11 Wireless Diagnostics
Command
Current SSID
Current Channel
Signal Strength
Access Point Mac
ENWW
This command is not compatible with the Shared Key
authentication option in the auth-type command. Use this
command to specify WPA-PSK authentication.
PSK: WPA-PSK provides enhanced authentication where
an authentication server is not used. Instead, a Pre-shared
key provides device authentication. A Pre-shared key is
generated when you specify a network pass-phrase using
the psk-passphrase command. The dynamic-encrypt
command should be set to the Robust option.
Specify a pass-phrase that is used to generate a network
Pre-shared key. A pass-phrase must be from 8 to 63 ASCII
characters in the hexadecimal range 21 through 7E
(characters 0-9, a-z, A-Z and numerous special characters
including !, @, #, $, %, ^, &, (, ), _, +, =, -, {, }, [, ], \, /, ", <,
>, ?, ", ', ~).
For WPA-PSK authentication, use this command to set the
print server for dynamic Wi-Fi Protected Access (WPA)
encryption. Specify Robust as the command option.
Description
(Read-only parameter) The network name (SSID) to which
the wireless print server connected.
(Read-only parameter) The channel that the wireless print
server is currently using.
(Read-only parameter) The strength of the radio signal
received by the print server.
<blank>: No radio signal detected while the print server is
scanning.
No Signal: No radio signal detected on any channel.
Poor/Marginal/Good/Excellent: Indicates the detected
signal strength level.
(Read-only parameter) The Media Access Control (MAC)
address of the Access Point used for Infrastructure mode
communications. For example,
00:a0:f8:38:7a:f7
specifies that the Access Point with MAC address
00a0f8387af7 was used for communicating on the network.
TCP/IP Configuration 82