HP Ew2400 - JetDirect Print Server Administrator's Manual page 124

Table 4.8 Miscellaneous Settings (2 of 5)
Item
Link settings
Network
Connection
Primary DNS
Server
Secondary DNS
Server
Email (SMTP)
Server
ENWW
Description
(For wired 10/100TX networks only) Set the network link
speed(10 or 100 Mbps) and communication mode (full- or
half-duplex) for HP Jetdirect 10/100TX print servers. The
available settings are listed below.
CAUTION: If you change the link setting, network
communications with the print server and network device may
be lost.
AUTO: (Default) The print server uses autonegotiation to
match the network's link speed and communication mode. If
autonegotiation fails, 100TXHALF is set.
10TXFULL: 10 Mbps, full-duplex operation
10TXHALF: 10 Mbps, half-duplex operation
100TXFULL: 100 Mbps, full-duplex operation
100TXHALF: 100 Mbps, half-duplex operation
HP Jetdirect ew2400 wired/wireless print servers support a
network connection using either a wired 802.3 port using a
network cable, or a wireless 802.11 port. However, only one port
can be active at a time. For these print servers, you should specify
the active port behavior.
AUTO (Cable Detect): Automatically detects whether an
802.3 network cable is attached. If a network cable is not
attached, only the 802.11 wireless port will be active.
However, if a network cable is attached, then only the 802.3
wired port will be active.
Disable Wire: Disables the 802.3 wired port, whether or not a
network cable is attached. Only the 802.11 wireless port will
be active.
Disable Radio: Disables the 802.11 wireless port. Only the
802.3 wired port will be active.
Specify the IP address of the primary DNS (Domain Name
System) server.
Specify the IP address of a secondary DNS server to use if the
primary DNS server is unavailable.
Specify the IP address of the preferred outgoing e-mail Simple
Mail Transport Protocol (SMTP) server, for use with supported
Scan devices.
Using the Embedded Web Server 124