HP Ew2400 - JetDirect Print Server Administrator's Manual page 226

Table 9.11 Error Messages (2 of 11)
Error Code and
Message
09 SCANNING FOR
SSID
0A LAN ERROR -
NO SQE
0C LAN ERROR -
RECEIVER OFF
0D LAN ERROR -
TRANSMITTER OFF
0E LAN ERROR -
LOSS OF CARRIER
10 LAN ERROR -
UNDERFLOW
11 LAN ERROR -
RETRY FAULTS
12 LAN ERROR -
NO LINKBEAT
13 NETWORK
RECONFIG - MUST
REBOOT
ENWW
Description
(802.11 Wireless) The print server is scanning on all
channels for devices on the specified SSID (network name).
Check your specified SSID, or check status of the Access
Point (Infrastructure mode) or other wireless devices.
The print server will continue to scan for the specified SSID.
(Wired Ethernet) Check the network connections. If the
connections are intact, run the power-on self-test: turn the
printer off, then on again. If the error persists, replace the
HP Jetdirect print server.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the printer
is turned on again, there is a problem with the HP Jetdirect
print server.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is a
problem with the HP Jetdirect print server.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
(Wired Ethernet) There may be a problem with your network
cabling or the HP Jetdirect print server. Check the cabling
and connectors on your network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the printer off, then on again. If the error
persists, there is a problem with the HP Jetdirect print
server.
(Wired Ethernet) There is a problem with your network
cabling or external network configuration. Verify operation
of the hub or switch port.
With a 10/100 Base-TX port connected, this message is
displayed if Link Beat is not sensed. Check the network
cable, and verify that the concentrator/hub is providing Link
Beat.
Reset or power off/on the HP Jetdirect print server to enable
new configuration values.
HP Jetdirect Configuration Page 226