HP Ew2400 - JetDirect Print Server Administrator's Manual page 91

Table 3.4 Telnet Commands and Parameters (13 of 18)
set-cmnty-name
default-get-cmnty
SNMP Traps
Command
auth-trap
trap-dest
IPX/SPX
Command
ipx-config
ipx-unitname
Address
ENWW
Specifies a password that determines which SNMP
SetRequests (control functions) the HP Jetdirect print server
will respond to. The community name of an incoming SNMP
SetRequest must match the print server's "set community
name" for the print server to respond. (For additional
security, you may limit configuration access through the print
server's host access list.) Community names must be ASCII
characters. The maximum length is 255 characters.
Enables or disables the default Get community name.
0 disables, 1 (default) enables.
Disabling this parameter may prohibit communications with
SNMP management applications.
Description
Configures the print server to send (on) or not send (off)
SNMP authentication traps. Authentication traps indicate
that an SNMP request was received, but the community
name check failed. 0 is off, 1 (default) is on.
Enters a host IP address into the HP Jetdirect print server's
SNMP trap destination list. The command format is:
trap-dest: ip-address [community name] [port number]
The default community name is 'public'; the default SNMP
port number is '162'. The port number cannot be specified
without a community name.
To delete the table, use 'trap-dest: 0'.
If the list is empty, the print server does not send SNMP
traps. The list may contain up to three entries. The default
SNMP Trap Destination List is empty. To receive SNMP
traps, the systems listed on the SNMP trap destination list
must have a trap daemon to listen to those traps.
Description
Enables or disables IPX/SPX protocol operation on the print
server. 0 disables, 1 (default) enables. For example,
ipx-config 0 will disable IPX/SPX operation.
(Print Server Name) A user-assigned alphanumeric name
assigned to the print server (31 characters maximum). By
default, the name will be NPIxxxxxx, where xxxxxx are the
last six digits of the LAN hardware address.
(Read-only parameter) Identifies the IPX network and node
numbers detected on the network, in the form
NNNNNNNN:hhhhhhhh (hexadecimal), where
NNNNNNNN is the network number and hhhhhhhh is the
LAN hardware address of the print server.
TCP/IP Configuration 91