Mode Button Setting; Obtaining The Autonomous Access Point Image File - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Chapter 4 Troubleshooting Lightweight Access Points

MODE Button Setting

The lightweight access point MODE button is configured from your Cisco Wireless LAN Controller. Use
these controller CLI commands to view and configure the MODE button:
1) config ap rst-button enable <access-point-name>/all
2) config ap rst-button disable <access-point-name>/all
3) show ap config general <access-point-name>

Obtaining the Autonomous Access Point Image File

The autonomous access point image file can be obtained from the Cisco.com software center using these
steps:
To download software from the Cisco.com software center, you must be a registered user. You can
Note
register from the main Cisco.com web page at this URL: http://www.cisco.com.
Use your Internet browser to access the Cisco Software Center at the following URL:
Step 1
http://www.cisco.com/cisco/software/navigator.html
Click Access Points > Cisco Aironet 1130 AG Series.
Step 2
Click Cisco Aironet 1130AG Access Point.
Step 3
On the Enter Network Password window, enter your Cisco.com username and password and click OK.
Step 4
Click IOS.
Step 5
Step 6 Choose the Cisco IOS release desired, such as 12.3.8.JA.
Step 7 Click WIRELESS LAN for an access point image file, such as c1130-k9w7-tar.123-8.JA.tar.
Step 8 On the Enter Network Password window, enter your Cisco.com username and password and click OK.
On the Security Information window, click Yes to display non-secure items.
Step 9
On the Encryption Software Export Authorization page, read the information and check Yes or No to the
Step 10
question asking if the image is for use by you or your organization. Click Submit..
If you checked No, enter the requested information and click Submit.
Step 11
Click Yes to continue.
Step 12
Click DOWNLOAD.
Step 13
Read and accept the terms and conditions of the Software Download Rules.
Step 14
On the Enter Network Password window, enter your Cisco.com username and password and click OK.
Step 15
Click Save to download your image file to your hard disk.
Step 16
Select the desired download location on your hard disk and click Save.
Step 17
OL-8369-05
(Where access-point-name is the name that identifies the access point on the
ocntroller.)

Obtaining the Autonomous Access Point Image File

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
4-11