Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual page 41

Chapter 2 Installing the Access Point
Follow these steps to mount the access point above a suspended ceiling. Refer to
proceeding.
Figure 2-8
1
2
3
Insert the bracket mounting clip's tab into the rectangular hole on the access point mounting bracket.
Step 1
Place the clip over the T-bar box hanger (refer to
Step 2
bracket with the 1/4-20 fastener (supplied with the T-bar hanger).
Figure 2-9
Remove a ceiling tile adjacent to the mounting location.
Step 3
Configure the ends of the T-bar box hanger to allow for maximum clearance above the ceiling tile. See
Step 4
the illustration above.
Open the access point cover and connect the Ethernet cable to the access point (see the
Step 5
an Ethernet Network with an Inline Power Source" section on page
Attach the access point to the access point mounting bracket (see the
Step 6
Mounting Plate" section on page
Attach the T-rail clips on the each end of the T-bar box hanger to the ceiling grid T-rails. Make sure the
Step 7
clips are securely attached to the T-rails.
OL-8369-05
T-Bar Grid Mounting Bracket Parts
6
Suspended ceiling T-rail
T-bar box hanger
Bracket mounting clip
T-Bar and Mounting Bracket
Mounting the Access Point Above a Suspended Ceiling
1 3
4
5
4 Access point mounting bracket
5
Access point
6
T-rail clip
Figure 2-9) and secure it to the access point mounting
2-16).
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Figure 2-8 before
6
2
1
"Connecting to
2-22).
"Attaching the Access Point to the
2-15