Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual page 43

Chapter 2 Installing the Access Point
In the cable bay area, line up the visible access point keyhole with the mounting plate keyhole clip
Step 3
located near the security padlock hole (see
Figure 2-10
1
Access point keyhole
2 Mounting plate
3 Mounting plate keyhole clip
Insert the keyhole clip into the keyhole and maintain a slight pressure to hold the access point in place.
Step 4
Slightly rotate the access point from side-to-side until you hear the second keyhole clip falling into the
Step 5
other keyhole that is located on the opposite end of the access point and is not visible.
Slide the access point back over the keyhole clips. You will hear a click when the locking detent contacts
Step 6
the access point and locks it into place.
For instructions on connecting your cables, refer to the
section on page
For instructions on securing your access point, refer to the
page 2-18.
OL-8369-05
Aligning the Keyhole Clip to the Access Point Keyhole
1
2
3
2-21.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Attaching the Access Point to the Mounting Plate
Figure 2-10).
5
4
4
Security screw hole
5 Padlock hole
"Connecting the Ethernet and Power Cables"
"Securing the Access Point" section on
2-17