Mode Button Setting; Obtaining The Autonomous Access Point Image File - Cisco AIR-AP1251AG-A-k9 Hardware Installation Manual

Obtaining the Autonomous Access Point Image File

MODE Button Setting

The lightweight access point MODE button is configured from your Cisco Wireless LAN Controller. Use
these controller CLI commands to view and configure the MODE button:
1) config ap rst-button enable <access-point-name>/all
2) config ap rst-button disable <access-point-name>/all
3) show ap config general <access-point-name>

Obtaining the Autonomous Access Point Image File

The autonomous access point image file can be obtained from the Cisco.com software center using these
steps:
Note To download software from the Cisco.com software center, you must be a registered user. You can
register from the main Cisco.com web page at this URL: http://cisco.com.
Step 1 Use your Internet browser to access the Cisco Software Center at the following URL:
http://tools.cisco.com/support/downloads/pub/MDFTree.x?butype=wireless
Step 2 On the Enter Network Password window, enter your Cisco.com username and password and click OK.
Click Access Points > Aironet Access Points > Cisco Aironet 1250 Series.
Step 3
Click Cisco Aironet 1250 Access Point.
Step 4
Click IOS.
Step 5
Step 6 Choose the Cisco IOS release desired, such as 12.3.11.JA.
Click Wireless LAN for an access point image file, such as c1250-k9w7-tar.123-11.JA.tar.
Step 7
Step 8 Click DOWNLOAD.
Step 9 Read and accept the terms and conditions of the Software Download Rules.
Step 10 On the Enter Network Password window, enter your Cisco.com username and password and click OK.
Click Save to download your image file to your hard disk.
Step 11
Select the desired download location on your hard disk and click Save.
Step 12
When the download completes, click Close.
Step 13
Close your browser.
Step 14
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
4-14
C I S C O C O N F I D E N T I A L - D r a f t A 1
(Where access-point-name is the name that identifies the access point on the
ocntroller.)
Chapter 4 Troubleshooting 1250 Series Lightweight Access Points
OL-8247-02