Running The Ping Test - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 1130AG - Aironet - Wireless Access Point:
- Hardware installation manual (138 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (13 pages)
Table of Contents
Advertisement
Chapter 3
Troubleshooting Autonomous Access Points
Click Start to begin the carrier busy test.
Step 6
When the test completes, the results are displayed on the screen. For each of the channel center
frequencies, the test produces a value indicating the percentage of time that the channel is busy.
Running the Ping Test
You can use the ping test to evaluate the link to and from an associated wireless device. The ping test
provides two modes of operation:
a.
b.
Follow these steps to activate the ping test:
Step 1
Use your web browser to access the access point browser interface.
Step 2
At the prompt, enter the administrator username and password. The default username is Cisco and the
default password is Cisco. The username and password are case sensitive.
Step 3
Click Association and the main association page appears.
Step 4
Click the MAC address of an associated wireless device and the Statistics page for that device appears.
Step 5
Click the Ping/Link Test tab and the Ping/Link Test page appears.
If you want to specify the number of packets to use in the test, follow these steps:
Step 6
a.
b.
If you want to use a continuous test, follow these steps:
Step 7
a.
b.
c.
When the test has completed, the test results are displayed at the bottom of the page. You should check
for any lost packets that can indicate a problem with the wireless link. For best results, you should also
perform this test several times.
OL-8369-05
Performs a test using a specified number of packets and then displays the test results.
Performs a test that continuously operates until you stop the test and then displays the test results.
Enter the number of packets in the Number of Packets field
Enter the packet size in the Packet Size field and click Start.
Enter the packet size in the Packet Size field.
Click Start to activate the test.
Click Stop to stop the test.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Running the Ping Test
3-15
Hide quick links:
Advertisement
Table of Contents
