Obtaining The Tftp Server Software - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Chapter 3 Troubleshooting Autonomous Access Points
Figure 3-3
1
Set up a terminal emulator on your PC to communicate with the access point. Use the following settings
Step 3
for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
At the prompts, enter the administrator username and password. The default username is Cisco and the
Step 4
default password is Cisco. The username and password are case sensitive.
When you have finished using the console port, you must remove the serial cable from the access point.

Obtaining the TFTP Server Software

You can download TFTP server software from several web sites. Cisco recommends the shareware TFTP
utility available at this URL:
http://tftpd32.jounin.net
Follow the instructions on the website for installing and using the utility.
OL-8369-05
Console Port Location
1
Console port
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

Obtaining the TFTP Server Software

3-21