Connecting To The Access Point Locally; Obtaining The Tftp Server Software - Cisco Aironet 1240AG Series Hardware Installation Manual

Connecting to the Access Point Locally

Connecting to the Access Point Locally
If you need to configure the access point locally (without connecting the access point to a wired LAN),
you can connect a PC to its console port using a DB-9 to RJ-45 serial cable.
Caution Be careful when handling the access point, the bottom plate might be hot.
Note After completing your configuration changes, you must remove the serial cable from the access point.
Follow these steps to open the CLI by connecting to the access point console port:
Step 1 Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 console port on the access point and
to the COM port on a computer.
Figure 3-3
Figure 3-3
1
Note
Step 2 Set up a terminal emulator on your PC to communicate with the access point. Use the following settings
for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Obtaining the TFTP Server Software

You can download TFTP server software from several web sites. Cisco recommends the shareware TFTP
utility available at this URL:
http://tftpd32.jounin.net
Follow the instructions on the website for installing and using the utility.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
3-20
shows the console port location.
Console Port Location
STATUS
RADIO
ETHERNET
2.4 GHz LEFT
Console port
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
http://www.cisco.com/go/marketplace
Chapter 3 Troubleshooting 1240AG Series Autonomous Access Points
CONSOLE ETHERNET
MODE
1
to order a serial cable.
48VDC
2.4 GHz RIGHT/PRIMARY
OL-8371-05