Attachments Window - Compaq 204451-002 - UPS T2200 XR Reference Manual

3-20 Compaq Power Products Software Reference Guide

Attachments Window

4. In the Alert Handling window, select the Close button to save the
settings or the Reset Defaults button to reset the default settings.
IMPORTANT: The first time Compaq Power Management software is run, the server must
be assigned to a load segment (before the UPS knows where the server resides). This
must be done before any other parameters can be set.
The attachments window allows assignment of the server to load segments,
otherwise individual control of all load segments is not possible.
Load shedding is the ability to divide the total load into segments and to start
and stop each load segment individually. Use the Attachments window to
configure the UPS load segments, enabling load shedding. If load shedding is
not enabled, the computer and all peripherals attached to the UPS shut down at
the end of the shutdown delay and restart immediately after a power failure,
when power is restored.
Use the shutdown schedule window (explained later in this chapter) to set a
shorter Power Fail Runtime for non-essential peripherals. Use the UPS Startup
Timing window to delay the restart of non-essential peripherals.
To enable load shedding, attach the computer and peripheral load segment
groups to the rear of the Compaq UPS, and configure the loads in the
Attachments window. For detailed information on the load segment
configuration, refer to the documentation included with the UPS kit.