Plustek OPTICPRO 12000P TURBO User Manual page 10

should refer to For OpticPro 9636T/12000T/9636P Turbo/12000P Turbo Scanners on
page 3.
1. Turn off and unplug the power cords to your computer and printer.
2. Please take a moment to study Figure 3A.
Printer
3. If you have a printer connected to your computer, please disconnect its cable
from the rear of the computer (see Figure 3A, Step 1).
4. Next, plug the same end of the disconnected printer cable into the PRINTER
port on the rear of the scanner (see Figure 3A, Step 2).
5. Eliminate any ESD (Electro Static Discharge) from the scanner cable by
touching its metal connector to any metal portion of your computer.
Danger
6. Plug the SCANNER CABLE into the scanner (see Figure 3A, Step 3) port
marked HOST.
7. Connect the other end of the SCANNER CABLE into the PCs parallel printer
port (see Figure 3A, step 4).
Attention
8. After plugging the scanner and printer cables into the correct locations, plug
the power adapter into the scanner's power receptor (see Figure 3A, step 5).
Rear of Scanner
Figure 3A. Connecting the Scanner
If you do not have a printer connected to your computer or you are not
sure where the parallel printer port is, see your computer's
information book and locate the section that refers to the
parallel port, printer port or LPT1.
Rear of Computer
2