Skoda SUPERB - 05-2009 Manual page 82

– Engage reverse gear.
– Move the right exterior mirror into the desired position ⇒ page 76.
– Take the vehicle out of gear. The set position of the exterior mirror is
stored.
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the three
A ⇒ page 80, fig.
memory buttons
B
corresponding memory button
cally moved into the positions which have been allocated to this button ⇒ page 81.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
Note
•
For safety reasons, it is not possible to store this position if the inclination angle
of the seat backrest is more than 102° in relation to the seat cushion.
•
When storing settings with the memory buttons, we recommend that you begin
with the front button and assign a memory button to each additional driver.
•
Each new setting stored with the same button erases the previous setting.
•
Each time you store the seat and exterior mirror settings for driving forward you
also have to re-store the individual setting of the exterior mirror on the passenger
side for reversing.
Assigning remote control to the memory buttons
After storing the settings of the seat and exterior mirrors, you have 10
seconds in order to assign the radio remote control to the appropriate
memory button.
– Withdraw the ignition key.
Using the system Safety
80, that is three in total. After pressing the
A
, the seat and the exterior mirror are automati-
B
Driving Tips
– Press the unlock button ⇒ page 51, after the successful assignment
an audible signal will sound. The setting is stored with the memory
button which you have selected.
If you wish to be able to retrieve the settings which are stored in the memory by also
using the radio remote control, you have to assign the radio remote control to a
memory button in each case.
If you wish, you can obtain an additional remote control key from an authorised
Škoda Service partner and then assign the remote control key to another memory
button.
Note
•
If the radio remote control had previously been assigned to another memory
button, this setting is then erased by the new assignment.
•
If you assign the radio remote control to a memory button which has already
been assigned to a radio remote control, the old assignment is also replaced by a
new assignment in this case.
•
The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the memory buttons
or with the remote control*.
Retrieving settings with memory buttons
– In order to retrieve the stored setting, you have two possibilities:
– One-touch automatic memory: Briefly press the desired memory
A ⇒ page 80, fig.
button
B
automatically into the stored positions (this applies only if the ignition
is switched on and the speed is less than 5 km/h).
General Maintenance Breakdown assistance
Seats and Stowage
80. The seat and exterior mirror are moved
Technical Data
81