Attaching A Child Seat Using The "Isofix" System - Skoda SUPERB - 05-2009 Manual

Hide thumbs Also See for SUPERB - 05-2009:
Table of Contents

Advertisement

Children of more than 150 cm in height may use the seat belts fitted to the vehicle
without a seat bolster.
WARNING
When transporting a child on the front passenger seat, please comply
with the appropriate national regulations regarding the use of child safety
seats. If required, the airbag has to be deactivated,
− in a specialist garage
− or by using the switch for the front passenger airbag* ⇒ page 183,
"Switch for the front passenger airbag*".
The shoulder part of the seat belt must run approximately across the
middle of the shoulder and fit snugly against the chest. It must on no account
run across the neck. The lap part of the seat belt must run across the pelvis
and fits snugly; it must not run over the belly. Tighten the belt webbing over
your hip if necessary.
Please comply with any differing national legal regulations regarding the
use of child safety seats.

Attaching a child seat using the "ISOFIX" system

Using the system
Safety
Fig. 187 Locking eyes
(ISOFIX system)
Driving Tips
General Maintenance
There are two fixing eyes* between the backrest and the seat of the front
passenger as well as on the rear exterior seats for fixing the "ISOFIX"
system child seat in place. On seats where the fixing eyes are not visible,
the places which have eyes are marked with signs with the "ISOFIX" logo
⇒ fig.
187.
Install child seat
A
– Insert the mounting funnels
A
seat backrest and the seat cushion
– Push the notched arms of the child seat over the mounting funnels
into the locking eyes, until it is heard to lock
– Pull on both sides of the child seat!
One can mount a child safety seat using the "ISOFIX" system quickly, easily and reli-
ably. Please pay close attention to instructions from the manufacturer of the child
safety seat when installing and removing the seat.
Child seats fitted with the "ISOFIX" system can only be mounted and fixed in a
vehicle fitted with an "ISOFIX" system when these child seats have been released for
this type of vehicle according to the ECE-R 44 standard.
Breakdown assistance
Transporting children safely
Fig. 188 The ISOFIX child
seat is pushed into the
mounting funnels
A
onto the locking eyes
between the
B
⇒ fig.
187.
⇒ fig.
188.
Technical Data
191

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superb

Table of Contents