Skoda SUPERB - 05-2009 Manual page 115

114 Air conditioning system
Using the system
So that the auxiliary heating (auxiliary heating and ventilation) func-
tions according to your expectations, it is necessary to carry out the
basic setting before its programming.
Basic setting
– On the information display, select from the Main menu the menu
point Aux. heating.
– In the menu Aux. heating (auxiliary heating)
menu point Weekday and set the current day.
– Return to a higher level by selecting the menu point Back, i. e. in the
menu Aux. Heating (auxiliary heating).
– In the menu Aux. Heating select the menu point Running time and
set the desired operating period in steps of 5 minutes. The operating
period can be 10 to 60 minutes.
– By selecting the menu point Back, you will reach in the menu
Aux. Heating (auxiliary heating).
– In the menu Aux. heating (auxiliary heating) select the menu point
Mode.
– In the menu Mode select the desired mode Heating or Ventilation.
Programming
For the programming of the auxiliary heating (auxiliary heating and ventilation) in
the menu Aux. heating (Aux. heating) there are three pre-set times:
•
•
•
In each pre-set time, the day and the time (hour and minute) can be set for
switching on the auxiliary heating and/or ventilation.
An empty position can be found between Sunday and Monday when selecting the
Fig. 130 Information
day. If this empty position is selected, the activation is performed without taking
display: Aux. heating
into account the day.
If you leave the pre-set menu by selecting the menu Back or do not operate the
display for longer than 10°seconds, the set values are stored, but the pre-set time is
not active.
Both other pre-set times can be programmed and stored in the same way.
⇒ fig. 130 If you select the menu Activate after setting the desired values, appears on the
select the
display Pre-set time (weekday, hours, minute) activated! (Pre-set time
(weekday, hour, minute) activated! and the set pre-set time is active.
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating activates at the set time, it is necessary to pre-set a time
again.
Changing the active pre-set time is carried out after selecting the menu point
Activate in the menu Aux. heating (auxiliary heating) by selecting a pre-set time.
The prerequisite for the correct switching on of the auxiliary heating (auxiliary
heating and ventilation) according to the programmed pre-set time is the correct
setting of the current time and the weekday ⇒ page 114.
Pre-set time 1
Pre-set time 2
Pre-set time 3