Skoda SUPERB - 05-2009 Manual page 81

80 Seats and Stowage
Adjust the angle of the seat
A
– Press the switch at the front
B
A ⇒ page 79, fig.
79.
3
Adjusting the seat backrest
A ⇒ page 79, fig. 78
– Press the switch
C
setting.
Adjusting lumbar support
A
– Press the switch front
A
curvature of the lumbar support.
A
– Press the switch rear in order to reduce the curvature of the lumbar
A
support.
A
– Press the switch top in order to adjust the curvature of the lumbar
A
support higher.
A
– Press the switch bottom in order to adjust the curvature of the
A
lumbar support lower.
A
Switch is operated in order to move the seat up/down and forward/back, while
B
A
switch is operated in order to move the backrest forward or back.
C
WARNING
•
Only adjust the driver seat when the vehicle is stationary - risk of injury!
•
Caution when adjusting the seat! You may suffer injuries or bruises as a
result of adjusting the seat without paying proper attention.
•
In view of the fact that the seats can also be adjusted when the ignition is
switched off (even when ignition key withdrawn), you should never leave
children unattended in the car.
•
The seat backrests must not be angled too far back when driving other-
wise this will affect proper operation of the seat belts and of the airbag
system - risk of injury!
A ⇒ page 79, fig. 79
or at the back
2
in the direction of the desired
⇒ page 79, fig. 78
in order to enlarge the
Note
If the movement of the seat is inadvertently interrupted during an adjustment, once
again press the switch in the appropriate direction and continue with the adjust-
ment of the seat to the end.
Storing setting
Storing seat and exterior mirror settings for driving forward
– Switch on the ignition.
– Adjust the seat ⇒ page 79.
– Adjust both exterior mirrors ⇒ page 76.
A ⇒ fig.
– Press button SET
80.
A
– Press one of the memory buttons
the button SET - an acknowledgement signal confirms that the seat
setting is stored..
Storing exterior mirror setting for reversing*
– Switch on the ignition.
– Turn the exterior mirror control to position
Fig. 80 Driver seat: Memory
buttons and SET button
A
within 10 seconds after pressing
B
 ⇒ page 76.